Chapter – 12
Magnetic Effects of Electric Current
1. Introduction
In 1820, Hans Christian Oersted noticed that a compass needle moved when current flowed in a nearby wire. This showed that electricity and magnetism are linked. Electric motors, fans, generators and MRI machines all work on this idea.
2. Magnetic Field and Field Lines
- The region around a magnet where its force can be felt is the magnetic field. It has both size and direction.
- A compass needle is a small magnet; its north-seeking end points north.
- Magnetic field lines show the field. Iron filings sprinkled around a bar magnet arrange themselves along these lines.
Properties of magnetic field lines:
- Outside the magnet they go from the north pole to the south pole; inside, from south to north. They are closed curves.
- Where lines are closer, the field is stronger (near the poles).
- Two field lines never cross, because the compass needle would then point in two directions at one place, which is impossible.
3. Magnetic Field due to a Current-Carrying Conductor
| Conductor | Field pattern | Strength depends on |
| Straight wire | Concentric circles around the wire | Increases with current; decreases with distance from wire |
| Circular loop | Circles near the wire; nearly straight lines at the centre | Current and number of turns (n turns give n times the field) |
| Solenoid (long coil) | Like a bar magnet outside; uniform, parallel lines inside | Current and number of turns |
Right-hand thumb rule: hold the current-carrying straight conductor in your right hand with the thumb pointing in the direction of current. The curled fingers show the direction of the magnetic field lines.
Electromagnet: a soft iron core placed inside a solenoid becomes a strong magnet while current flows. It loses its magnetism when current stops. Electromagnets are used in cranes, electric bells and loudspeakers.
| Bar magnet (permanent) | Electromagnet |
| Magnetism stays all the time | Magnetism only while current flows |
| Fixed strength | Strength can be changed by changing current or turns |
| Fixed poles | Poles can be reversed by reversing the current |
4. Force on a Current-Carrying Conductor in a Magnetic Field
A current-carrying conductor placed in a magnetic field experiences a force (André-Marie Ampère suggested that the magnet also experiences an equal and opposite force).
- The force is largest when the current is perpendicular to the magnetic field.
- Reversing either the current or the field reverses the direction of the force.
Fleming’s left-hand rule: stretch the thumb, forefinger and middle finger of your left hand so that they are mutually perpendicular.
- Forefinger → Field direction
- Middle finger → Current direction
- Thumb → Motion (force) on the conductor
Easy Memory Trick: “FBI” from thumb downward: thumb = F (force), forefinger = B (magnetic field), middle finger = I (current).
Uses: electric motors, loudspeakers, electric fans, washing machines, MRI. Electric motors convert electrical energy into mechanical energy.
In medicine: weak currents in nerve cells produce tiny magnetic fields in the body. The heart and brain have important magnetic fields; MRI (Magnetic Resonance Imaging) uses this to get images of internal organs.
5. Domestic Electric Circuits
- Electricity reaches our homes through the mains: a live wire (red insulation, positive) and a neutral wire (black insulation, negative). In India the potential difference between them is 220 V, at a frequency of 50 Hz (AC).
- The earth wire (green insulation) is connected to a metal plate buried deep in the earth near the house. It is joined to metallic bodies of appliances like irons, fridges and toasters. If current leaks to the body, it flows safely to the earth, and the user does not get a severe shock.
- The main supply passes through a meter and a main fuse, then to a distribution box with separate circuits.
- Two circuits are commonly used: a 15 A line for high-power appliances (geysers, air coolers) and a 5 A line for bulbs and fans.
- All appliances are connected in parallel, each with its own switch, so each gets the same voltage.
Short circuit: when the live wire and neutral wire come into direct contact (due to damaged insulation or a fault in an appliance), the resistance becomes very small and the current rises suddenly.
Overloading: when too many appliances are connected to a single socket, or the supply voltage rises accidentally, too much current flows.
Safety devices: electric fuse and MCB (miniature circuit breaker). They cut off the supply when excess current flows, preventing damage and fire.
6. Important Questions
Q1. Why does a compass needle get deflected when brought near a bar magnet?
Ans. The compass needle is a small magnet; the magnetic field of the bar magnet exerts a force on its poles.
Q2. Why don’t two magnetic field lines intersect?
Ans. At the point of intersection, the compass would point in two directions at once, which is impossible.
Q3. What is the function of an earth wire? Why is it necessary to earth metallic appliances?
Ans. It provides a low-resistance path for leaking current to flow to the earth, so the metal body does not carry a dangerous voltage and the user is protected from shock.
Q4. Name some devices in which electric motors are used.
Ans. Electric fans, mixers, washing machines, refrigerators, water pumps.
Q5 (long). State Fleming’s left-hand rule. In which direction will a positively charged particle moving east be deflected by a magnetic field pointing north?
Ans. If the thumb, forefinger and middle finger of the left hand are stretched mutually perpendicular, with the forefinger along the magnetic field and the middle finger along the current, the thumb gives the direction of the force on the conductor. A positive charge moving east is like a current to the east. With the field to the north, the rule gives a force acting upward (vertically, out of the ground).
Assertion–Reason: A: Household appliances are connected in parallel. R: In parallel, each appliance gets the same voltage and can be switched on or off independently.
Ans. Both true; R explains A.
7. Conclusion
An electric current produces a magnetic field, and a magnetic field exerts a force on a current. The right-hand thumb rule and Fleming’s left-hand rule give the directions. These ideas power electric motors and make domestic wiring safe through earthing, fuses and MCBs.