Chapter – 1
Matter in Our Surroundings
1. Introduction
Everything around us that has mass and occupies space is called matter. Air, water, stone, food, our body and even the smallest dust particle are all matter. Ancient Indian philosophers classified matter into five basic elements (Panch Tatva): air, earth, fire, sky and water. Modern scientists classify matter on the basis of its physical properties and chemical nature.
2. Physical Nature of Matter
Matter is made up of particles. When we dissolve salt or sugar in water, the crystals disappear, but the water tastes salty or sweet. This shows that the salt breaks into tiny particles that spread between the particles of water.
Particles of matter are very small. A few crystals of potassium permanganate can colour a large amount of water (even after repeated dilution), which shows that a single crystal contains millions of tiny particles.
3. Characteristics of Particles of Matter
| Characteristic | Evidence / Activity |
| Particles have space between them | Sugar dissolves in water without raising the water level much. |
| Particles are continuously moving (they have kinetic energy) | Smell of incense sticks spreads; ink spreads in water (diffusion). |
| Particles attract each other | It is hard to break an iron nail; a stream of water stays together. |
Diffusion: The intermixing of particles of two different types of matter on their own is called diffusion. Diffusion becomes faster on heating, because particles get more kinetic energy.
Remember: The force of attraction between particles is strongest in solids, weaker in liquids and weakest in gases.
4. States of Matter
| Property | Solid | Liquid | Gas |
| Shape | Definite | Takes shape of container | No fixed shape |
| Volume | Definite | Definite | No fixed volume |
| Compressibility | Negligible | Very low | Very high |
| Space between particles | Least | More | Maximum |
| Force of attraction | Strongest | Medium | Weakest |
| Fluidity | Do not flow (rigid) | Flow | Flow |
| Diffusion | Very slow | Faster | Fastest |
Interesting points:
- A rubber band changes shape when stretched but regains it; it is still a solid. A sponge is a solid with tiny holes that hold air.
- Sugar and salt take the shape of the container, but each crystal keeps its own shape, so they are solids.
- Gases are highly compressible. That is why LPG (liquefied petroleum gas) and CNG (compressed natural gas) can be stored in cylinders.
- Aquatic animals breathe oxygen dissolved in water; gases diffuse into liquids.
5. Can Matter Change its State?
(a) Effect of change of temperature
On heating, particles gain kinetic energy and vibrate faster. They overcome the forces of attraction and the solid melts.
- Melting point: The temperature at which a solid melts into a liquid at atmospheric pressure. Melting point of ice = 0 °C = 273.15 K.
- Latent heat of fusion: The heat energy required to change 1 kg of a solid into liquid at its melting point without any rise in temperature. The heat gets “hidden” in breaking the force of attraction.
- Boiling point: The temperature at which a liquid starts boiling at atmospheric pressure. Boiling point of water = 100 °C = 373 K.
- Latent heat of vaporisation: The heat required to change 1 kg of liquid into gas at its boiling point.
- Sublimation: Change of a solid directly into gas (or gas into solid) without becoming liquid. Examples: camphor, naphthalene, ammonium chloride, iodine. The reverse change (gas to solid) is called deposition.
Kelvin and Celsius: T (K) = t (°C) + 273. (Exact value: 273.15.)
Example: Convert 25 °C to kelvin. 25 + 273 = 298 K. Convert 300 K to °C. 300 − 273 = 27 °C.
Exam point: Particles of steam at 100 °C have more energy than water at 100 °C, because steam has absorbed extra energy as latent heat of vaporisation. That is why a burn from steam is more severe than from boiling water.
(b) Effect of change of pressure
Applying pressure and reducing temperature brings gas particles close together and can liquefy a gas. Solid carbon dioxide (dry ice) changes directly into gas when pressure is reduced to 1 atmosphere.
Units of pressure: 1 atmosphere (atm) = 1.01 × 105 Pa. Atmospheric pressure at sea level is 1 atm.
6. Evaporation
Evaporation is the change of a liquid into vapour at any temperature below its boiling point. It is a surface phenomenon: particles at the surface with enough energy escape into the air.
Factors affecting evaporation:
| Factor | Effect on rate of evaporation |
| Increase in surface area | Increases (clothes are spread out to dry) |
| Increase in temperature | Increases |
| Increase in humidity | Decreases (clothes dry slowly on rainy days) |
| Increase in wind speed | Increases |
Evaporation causes cooling: The particles of the liquid take energy from the surroundings to evaporate, so the surroundings become cool.
- Acetone (nail polish remover) on the palm feels cold.
- Water kept in an earthen pot (matka) becomes cool.
- We sweat more in summer; evaporation of sweat cools our body.
- Cotton clothes are better in summer because they absorb sweat and let it evaporate.
- Water droplets form on the outer surface of a glass of ice water because water vapour in the air condenses on the cold surface.
7. Difference between Evaporation and Boiling
| Evaporation | Boiling |
| Takes place at all temperatures below the boiling point | Takes place at a fixed temperature (boiling point) |
| Surface phenomenon | Bulk phenomenon (whole liquid) |
| Slow process; causes cooling | Fast process; needs continuous heating |
8. Easy Memory Trick
“S-L-G: Strong, Less, Gone” — force of attraction is Strong in solids, Less in liquids and almost Gone in gases.
9. Important Questions
Q1. Convert into kelvin: (a) 300 °C (b) 573 °C.
Ans. (a) 300 + 273 = 573 K (b) 573 + 273 = 846 K.
Q2. Why does a desert cooler cool better on a hot, dry day?
Ans. On a hot, dry day, temperature is high and humidity is low, so water evaporates faster and produces more cooling.
Q3. Why does the temperature stay the same while ice melts?
Ans. The heat supplied is used to break the force of attraction between particles (latent heat of fusion), not to raise the temperature.
Q4. Why are gases highly compressible?
Ans. Because the particles of a gas have large spaces between them.
Q5. Give two examples of sublimation.
Ans. Camphor and naphthalene (also ammonium chloride, iodine).
Assertion–Reason: Assertion (A): We feel cool after a bath on a hot day. Reason (R): Evaporation of water from the body absorbs heat.
Ans. Both A and R are true and R is the correct explanation of A.
10. Conclusion
Matter is made of tiny moving particles with spaces and attraction between them. Changing temperature or pressure changes its state, and evaporation is a useful cooling process we see every day.