Circuit Builder

About this game

How to play Circuit Builder

Circuit Builder is a virtual electricity lab that runs right in your browser. Connect cells, bulbs, switches, resistors and meters using the circuit symbols from your NCERT textbook, and watch the current flow as soon as the circuit is complete. Real Ohm’s law calculations give accurate ammeter and voltmeter readings.

🎯 What it teaches

  • The difference between an open circuit and a closed circuit, and what a switch does.
  • How bulbs behave in series and in parallel, and why one bulb stays lit in a parallel circuit when another is removed.
  • How to connect an ammeter in series and a voltmeter in parallel, and how to read them.
  • Ohm’s law, V = I × R, and why a short circuit is dangerous.

🕹️ How to play

  1. Choose a part from the toolbar: wire, cell, bulb, switch, resistor, ammeter or voltmeter.
  2. Tap a gap between two dots on the board to place the part. Tap a switch to open or close it.
  3. Complete the loop back to the cell. Moving dots show the current, and bulbs glow brighter when more current flows.
  4. Tap any part to see the current through it and the voltage across it.
  5. Finish the eight missions, build anything in Free build, then answer 10 questions in the Quiz.

💡 Tips

  • Check that the loop connects back to both terminals of the cell.
  • To measure the voltage across a bulb, use wires to join the voltmeter to both ends of the bulb.
  • If you see the short circuit warning, add a bulb or a resistor to the loop.
  • Join two cells + to − to make a battery and watch the bulb glow brighter.
  • Your completed missions and best quiz score are saved on your device.

👥 Who it is for

Circuit Builder suits students of classes 6 to 10 who are learning about electricity, circuits and Ohm’s law in science and physics. Teachers can use it on a projector to demonstrate series and parallel circuits.

Free to play on computermafia.com. No sign-up, nothing to install.